Table of Contents
Advertisement
Symptom
Possible Cause
Pet is getting out.
• Power Cap
Unit is dead or weak.
• Computer Collar
the pet.
• Signal field wire has a break.
• Power is not supplied to the transmitter or
power is out.
• Pet needs additional training.
Pet will not enter
• Pet needs additional training.
the yard.
Computer
• Power Cap
Collar
Unit not
Unit is dead or weak.
®
responding to
• Signal field wire has a break.
signal field (loop)
• Power is not supplied to the transmitter or
wire.
power is out.
Battery Disposal
Separate collection of spent batteries is required in many regions; check the regulations in your area before discarding spent
batteries. The Computer Collar
Replace only with equivalent Power Cap
Transmitter operates on one (1) Valve Regulated Lead Acid Battery with a 12 Volt, 5Ah capacitym or 12 Volt, .8Ah capacity.
Computer Collar
Unit : Please see your manual for instructions on how to remove the Power Cap
®
disposal.
Transmitter: At the end of product life of the Transmitter, please contact your Invisible Fence
instructions on proper disposal of the backup battery (if installed). Please do not dispose of the backup battery in household
or municipal waste receptacle.
WARNING
Replacing the battery backup with a battery not specifically approved by Invisible Fence
all service to your Invisible Fence
Perchlorate Battery
Perchlorate Material – special handling may apply. See www.dtsc.ca.gov/hazardouswaste/perchlorate.
Important Recycling Advice
Please respect the Waste Electrical and Electronic Equipment regulations in your country. This equipment must be recycled.
If you no longer require this equipment, do not place it in the normal municipal waste system. Please return it to where it
was purchased so it can be placed in our recycling system. If this is not possible, please contact your Invisible Fence
Dealer.
Compliance
US and Canada
6
Troubleshooting
Battery in the Computer Collar
®
Unit is not fit properly on
®
Battery in the Computer Collar
®
Unit operates on one (1) Lithium (Li-MnO2) battery with a 3 Volt, 160 mAh capacity.
®
Battery that can be obtained from your Invisible Fence
®
®
Brand Dealer only.
www.invisiblefence.com
Action
• Replace the Power Cap
®
• Properly fit the collar.
• Contact your Invisible Fence
• Make sure transmitter power supply is plugged in.
• Contact your Invisible Fence
additional pet training.
• Contact your Invisible Fence
additional pet training.
• Replace the Power Cap
®
• Contact your Invisible Fence
• Make sure transmitter power supply is plugged in.
Brand, may cause fire or explosion. Refer
®
Battery.
®
Brand Dealer.
®
Brand Dealer for
®
®
Brand Dealer for
Battery.
®
Brand Dealer.
®
Brand Dealer. The
®
®
Battery for separate
Brand Dealer to receive
®
®
Brand
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the boundary plus and is the answer not in the manual?
Questions and answers
After lawn people were here I’m getting g a signal that line is cut and I can’t figure out where. I’ve disconnected it to stop the beeping .
To locate a cut signal line for an Invisible Fence Plus system:
1. Use a wire break locator and move it side to side along the wire path.
2. Listen and watch for changes in tone and light.
3. For twisted wire: a single break changes the tone; if both wires are broken, tones decrease then stop.
4. For boundary loop: a single break causes tone and light to change; multiple breaks cause tone to decrease then stop.
5. Turn down the volume on the locator when the tone changes to pinpoint the break—it disappears when directly over the break.
This answer is automatically generated