Maintenance Guide; Periodic Maintenance Check; Monthly Signal Field Width Test; Troubleshooting Guide - INVISIBLE FENCE Computer Collar 700 Series Owner's Manual

Your Invisible Fence ® Brand Dealer has professionally installed your pet containment system and ensured it is working
properly. You will want to perform periodic maintenance checks to make sure the system is properly functioning for your
pet's safe containment.
System Device
Transmitter
Signal Field Width

Monthly Signal Field Width Test

(Always perform this test after a thunderstorm)
You should always be aware of your system's signal field width.
Check the width of the signal field from only one place on the signal field
loop wire. Always check the signal field width from the same place. Take the
Computer Collar unit off your pet to measure the signal field width.
®
1. Hold the Invisible Fence
the signal field wire.
2. Hold the collar so it is about the same height and at the same angle as it
will be when the pet is wearing it.
3. Walk slowly toward the signal field wire. The receiver will activate when
you reach the edge of the signal field. Do NOT touch the correction posts
at this time!
If the receiver does not sound a warning tone where the edge of the signal
is supposed to be, immediately call your Invisible Fence Brand Dealer for
service. Use a leash or other means to contain your pet until all necessary
service has been completed.
Symptom Possible Cause
Pet is getting out. • Power Cap
is dead or weak.
• Computer Collar unit is not fit properly on
the pet.
• Signal field wire has a break.
• Power is not supplied to the transmitter or
power is out.
• Signal field is too narrow.
• Pet needs additional training.
Pet will not enter • Signal field is too high.
the yard. • Pet needs additional training.
6
Maintenance
Periodic Maintenance Checks
How often
Daily
Monthly and after a
thunderstorm
Brand Computer Collar unit so it is parallel to
®
Troubleshooting
unit in the Computer Collar unit
®
www.invisiblefence.com
What to look for
Check the LED Status Indicator Light (see page 5) on the
front of the unit to verify power.
Verify the signal field wire is active throughout the property,
see Monthly Signal Field Width Test below.
Signal Field Width: ___________________
Invisible Fence
Computer Collar
Action
• Replace the Power Cap
• See page 4 for properly fitting the collar.
• Contact your Invisible Fence
• Make sure transmitter power supply is plugged in.
• Contact your Invisible Fence Brand Dealer.
• Contact your Invisible Fence Brand Dealer for
additional pet training.
• Contact your Invisible Fence Brand Dealer to
check signal field.
• Contact your Invisible Fence Brand Dealer for
additional pet training.
Brand
®
® Unit
unit.
®
Brand Dealer.
®