Monthly Signal Field Width Test; Troubleshooting Guide - INVISIBLE FENCE 800 Series Owner's Manual

Titanium Computer
Collar unit
Signal Field Width

Monthly Signal Field Width Test

You should always be aware of your system's signal fi eld width.
Check the width of the signal fi eld from only one place on the signal fi eld
loop wire. Always check the signal fi eld width from the same place. Take the
®
Computer Collar unit off your pet to measure the signal fi eld width.
1. Hold the Invisible Fence
parallel to the signal fi eld wire.
2. Hold the collar so it is about the same height and at the same angle as it
will be when the pet is wearing it.
3. Walk slowly toward the signal fi eld wire. The receiver will activate when
you reach the edge of the signal fi eld. Do NOT touch the correction
posts at this time!
If the receiver does not sound a warning tone where the edge of the signal
is supposed to be, immediately call your Invisible Fence
for service. Use a leash (lead) or other means to contain your pet until all
necessary service has been completed.
Symptom Possible Cause
Pet is getting out. • Power Cap
Collar
• Titanium Computer Collar
properly on the pet.
• Signal fi eld wire has a break.
• Power is not supplied to the transmitter or
power is out.
• Signal fi eld is too narrow.
• Pet needs additional training.
Pet will not enter • Signal fi eld is too high.
the yard. • Pet needs additional training.
Computer Collar ® • Power Cap
unit not responding Collar
to signal fi eld • Signal fi eld wire has a break.
(loop) wire. • Power is not supplied to the transmitter or
power is out.
Daily
Monthly and after a
thunderstorm
®
Brand Titanium Computer Collar
Troubleshooting
® unit in the Titanium Computer
®
unit is dead or weak.
®
unit is not fi t
® unit in the Titanium Computer
®
unit is dead or weak.
www.invisiblefence.com
• Check Power Cap
• Review chart for status indicators (see page 5).
• Verify the signal fi eld wire is active throughout the
property, see Monthly Signal Field Width Test below.
Signal Field Width: ___________________
®
unit so it is
®
Brand Dealer
Action
• Replace the Power Cap
• See page 4
• Contact your Invisible Fence
• Make sure transmitter power supply is plugged in.
• Contact your Invisible Fence
• Contact your Invisible Fence
additional pet training.
• Contact your Invisible Fence
check signal fi eld.
• Contact your Invisible Fence
additional pet training.
• Replace the Power Cap
• Contact your Invisible Fence
• Make sure transmitter power supply is plugged in.
® Battery status light on top of unit.
®
Invisible Fence Brand
®
Computer Collar Unit
® unit.
for properly fi tting the collar.
®
Brand Dealer.
®
Brand Dealer.
® Brand Dealer for
® Brand Dealer to
®
Brand Dealer for
® unit.
®
Brand Dealer.
7