Routine Maintenance - Haier AFL-AFD Instructions For Use Manual

English

7. ROUTINE MAINTENANCE

IN OX
Cleaning the appliance
Disconnect the electrical power supply before starting
the job.
Internal cleaning
Clean all internal parts with tepid water and neutral
soap, vinegar or sodium bicarbonate, then dry
accurately. Alternatively use detergents made
specifically for the refrigerator, on sale in any
supermarket. Do not use abrasive detergents and/or
powders, soda based detergents, or solvents which
could damage the finish. To facilitate cleaning, the
internal accessories can be removed (consult parag.
"Dismantling components").
External cleaning
Clean all external parts with specific detergents. Do not use
abrasive detergents and/or powders, soda based detergents,
or solvents which could damage the finish.
Dismantling components
To facilitate cleaning operations, all the internal components
of the appliance can be dismantled. Follow the instructions in
the relevant figure.
A: Freezer drawers, fruit/vegetable drawer and "Fresh Control
0°C drawer": these drawers slide on special guides with stops,
which prevent the drawers coming out entirely when opened,
and risk falling on the floor. If you wish to take them out of the
appliance for the cleaning operations, extract them to up to
¾ of their depth, lift them up slightly and continue extracting,
keeping them inclined upwards.
B: Door balconies: they are simply fitted on the guides integrated
on the door. To remove them, lift them upward, firmly pushing
them up.
C: Freezer drawers: they cannot be fully removed from the
appliance for reasons of safety; when they have been opened
up to the maximum permitted extraction å the internal
drawers can be extracted by simply lifting them up ç.
D: Glass top in two pieces: the front top (D2) is connected to
the rear top to prevent the latter coming out accidentally
(see detail.ç); to remove it, slightly lift the rear top (D1) and
withdraw the front top (D2).
The rear top (D1) is restrained at its ends by two pins which
prevent it coming out accidentally (see detail é). To extract
it, lift it upward and pull it toward yourself until you withdraw
it. When you re-position the two tops (D1 and D2) make sure
you connect them once again to each other.
E: Top in glass with bottle holder: the top slides on guides,
and has two pins preventing the guides from coming out
accidentally(see detail å); if you wish to remove it from the
appliance for the cleaning operations ,lift it up slightly and
extract it, keeping it inclined upwards.
F: Glass top: the top slides on guides. If you wish to remove it
from the appliance for cleaning operations, take away the
"Fresh Control 0°C" drawer, slightly lift up the top and extract
it, continuing to hold it inclined upwards.
C
3
D1
E
F
17
A
2
D1
D1
D2
1
D3
B
C
D2