Direct Vcr Recording From An Antenna Or Cable Source - Mitsubishi Electric LT-3280 Owner's Manual

Direct VCR Recording from an
Antenna or Cable Source
Pressing REC (record) on the media center's remote
control will function the same way as pressing the record
button on the VCR's remote control or front panel.
To record directly from antenna or cable:
1. Press DEVICE on the media center's remote to display
the Device Selection menu. Highlight the traditional
VCR and press POWER to turn on the VCR. If
necessary, press GUIDE to select the input the VCR is
on, such as Antenna input (or line input).
2. Press ENTER to switch the media center to the VCR.
3. Select the correct channel for recording on the VCR
and then press REC to start recording. You will
need to manually stop the recording at the end of the
program.
OR...
4. Press the DEVICE MENU button to display the VCR's
menu to schedule a delayed recording directly from
antenna or cable.
To record from Ant-1, Ant-2 or other devices, see
NetCommand Controlled Recordings.
Chapter 4: IEEE 1394 Devices and NetCommand® Controlled Recordings
Copy-Protected Material
When attempting to record copy-protected material, the
Record functions of the NetCommand and IEEE 1394
systems may be prevented or stopped. If you have a
recording that is tagged "Record Once", NetCommand
will not allow the recording to be moved.
Restrictions for Traditional VCRs
If turned On, the media center must be tuned to the
source device.
• Your VCR should be connected directly to Monitor
Output Audio and Video.
• The VCR must be set manually to "Line Input".
Display the Device Selection menu, highlight the VCR
and press GUIDE to change VCR inputs.
• The media center can select channels on compatible
cable boxes for recordings. Leave the cable box
turned on.
• If the source device or recording device does not
have separate power On and Off features, then leave
that device powered On.
63