1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
Figure 1. Remote Control Overview
Remote Control Operation
Battery Installation
Figure 2
Installing the Batteries:
1. Remove the remote control's rear cover by gently
pressing the ribbed tab in the direction of the arrow
and sliding off the cover.
2. Load the batteries, making sure the (-) and (+)
polarities are correct. For best results, insert the
negative (-) side first.
17
18
19
20
21
Figure 2. Operation: Installing the Batteries
22
Care
23
For Best Results from the Remote Control:
24
• Be within 20 feet of the equipment.
25
• Do not press two or more buttons at the same
time unless instructed.
26
• Do not allow unit to get wet or become heated.
27
• Avoid dropping on hard surfaces.
28
• Do not use harsh chemicals to clean. Use only
a soft cloth, lightly moistened with water.
29
• Do not mix new and old batteries.
30
• Do not heat, take apart or throw batteries into fire.
31
• Use only AA alkaline batteries.
32
Hint: If the remote is in the Cable/DBS/DTV layer
and will not operate the media center, press and hold
POWER and enter 1, 9, 7 to reset the remote control.
33
34
Sleep Timer
Setting the Sleep Timer:
1. Press SLEEP on the remote control.
2. Each press of SLEEP increases the time displayed by
30 minutes, until the maximum value of 120 minutes
is reached.
3. After 5 seconds of inactivity, the message will
disappear.
4. Press SLEEP to view the remaining time before the
timer turns the TV off.
Canceling the Sleep Timer:
1. Press SLEEP to display the on-screen message.
2. Press SLEEP repeatedly until OFF is displayed.
Note: After 5 seconds of inactivity, the message box
disappears.
Chapter 1: Product Overview
13