Ac Power Cords - Mitsubishi Electric LT-3280 Owner's Manual

AC Power Cords

Figure 3. AC power cords for display and media center
After you have connected all A/V devices to the media
center, connect the display to a nearby AC wall outlet,
then connect the media center to a AC wall outlet. The
blue light next to the Power button on the front panel of
the media center will start blinking. Wait for the blinking to
stop (about 1 minute) before pressing the Power button on
the remote control.
Figure 3. Connecting display and media center power cords to AC wall outlets. Wait until after you have connected
all A/V devices to the medial center before plugging in the AC power cords.
NOTE: After a power outage (or after the media center
power cord has been accidentally unplugged), the blue
light on the front of the media center will start to blink.
• This is normal; the media center is re-initializing.
• Wait for the blue light to stop blinking (about 1 minute),
then press Power on the remote control.
IMPORTANT: Do not connect
power cords to AC outlets
until AFTER all A/V devices are
connected. Instructions for
connecting A/V devices are
provided in this chapter.
Chapter 2: Connecting
19