DVD Player or Other Component Video Device
Figure 12
Component video cables and audio cables are required. These are not included with the media center.
1. Connect the Component Video cables from Y/Pr/Pb VIDEO OUT on the back of the DVD player to COMP-2 on the
media center rear panel, matching the correct connection:
Y to Y (Green), Pr to Pr (Red), Pb to Pb (Blue)
2. Connect a set of audio cables from AUDIO OUT on the back of the DVD player to COMPONENT-1 AUDIO Input on
the media center rear panel. The red cable connects to the R (right) channel, and the white cable connects to the L
(left) channel.
NOTE: For the best audio quality, if your A/V receiver supports digital audio, connect the DVD Coaxial or Optical digital
audio directly to the A/V receiver (instead of using the L/R analog audio ports).
Figure 12. Connecting a DVD Player with Component Video
NOTE: NetCommand® will assume you connected your DVD player to Component-1. If you add a second DVD or use
any other inputs for your DVD, this change must match in the NetCommand system. See Edit NetCommand in Chapter
3 for more information.
IMPORTANT
See Appendix D for component video
signal compatibility information.
For digital audio connections, see
your DVD Owner's Guide.
Chapter 2: Connecting
27