Connections; Connecting To Cctv Camera, Monitor, And Sensor; Alarm Recording Connection - Mitsubishi Electric DX-TL4516U Installer Manual

Connections

Connecting to CCTV camera, monitor, and sensor

Dome camera
Camera #1
Up to 16 cameras
To CAMERA IN 1 connector
Power code
Processing the connecting line
Connection on the ALARM IN terminals, the I/O terminals, and RS485/RS422
Compatible power lines ø0.32 - ø0.65 mm (AWG 28 - 22)
Cut the designated area from the electric wire's outer covering
(vinyl portion).
You can connect various devices to control this unit from them, or to control them from this unit. However, depending on
the operational condition of this unit, the operational speed of this unit may become slower or control of the external device
may be delayed.
18
Clamp the power cord using the supplied
cable clamping band in order to prevent the
accidental removal of the cable.
( See page 20.)
To OUTPUT A VIDEO or
OUTPUT A S(Y/C) connector
Clamp the USB cable using the supplied
cable clamping band in order to prevent the
accidental removal of the cable.
( See page 20.)
To ALARM IN terminal To GND
corresponding to the terminal
camera #.
PTZ control connectors
RS422 type
dome camera
To VIDEO IN or
S(Y/C) IN connector
One of either codes
should be connected.
To OUTPUT B
connector
To SERIAL
BUS
RS232C type
dome camera
(camera controller)
5-7mm
Monitor
To VIDEO IN
connector
Monitor
To LAN
External recording device
DX-ZD5UE(Z)
Up to 7 units can be mounted
at the same time.
Mouse