Replacement Of Pc Temperature Sensor - Panasonic NR-BN31AS1 Service Manual

9.7.

Replacement of PC temperature sensor

1. Release the latches by screwdriver and remove the cover
by hand.
Note: The sensor cover is hooked at two position as
shown in the photo.
2. Cut off the damages sensor at the base of sensor head.
3. Strip off approx. 25mm of additional cable insulation and
5mm of basic insulation of the conductor.
4. First crimp the enclosed end splices on conductor of the
new sensor.
Place the enclosed thermo-shrinkable bushing.
Crimp end splices on conductors of cut cable.
5. Use hair dryer and heat the bushings so that they tightly
wrap the conductors and prevent moisture from breaking
through the joint.
6. Place the sensor into its seat and replace the sensor
cover.
36