Table of Contents
Advertisement
VANNER
Incorporated
2.2 Specifications
Model No.
Input:
Output:
DC Current Draw:
Bulk Voltage:
Float Voltage:
Ambient Temperature:
Cooling:
Chassis:
Weight:
Dimensions:
2.3 Standard Features
• Fully Automatic Operation with Three-stage Battery Charging
(Bulk, Absorption, and Float Stage Charging)
• Two Year Warranty
• Over Current Protection of AC Input and DC Output to Protect Both the Charger and the
Batteries
• Durable Steel Enclosure
• 3 Status LEDs Describe the Status of the Charger (Green/Amber), or Over
Temperature/Shutdown (Red) Condition
3 Installation and Checkout
NOTE
Charger should not
be installed in same
compartment as
batteries.
3.2 Charger Mounting
• Install Charger in horizontal position, (mounting brackets are attached to the unit). This unit
requires airflow under chassis for proper cooling.
Max SP00143/181 Battery Charger
Max SP00143/181 Battery Charger
SP00143
15A at 120VAC ±10%, 60Hz
41A at 24VDC Nominal
30 milliamperes (with no AC voltage applied)
28.6VDC Nominal
26.6VDC Nominal
-40 to +105°F (-40 to +40°C)
Forced Air, 100 CFM, 24VDC Fan with front to rear air flow
Steel with durable painted finish
35 lbs
9.85" W x 6.70" H x 15.75" D
3.1 Selection of Battery Charger Location
• Charger should be located close to battery (but not in the same
compartment) for optimum performance (within 3ft.)
• Charger should be protected from weather. Install charger in
compartments that provide protection from direct water spray,
dirt, or toxic vapor.
• Mounting compartment should be well-ventilated and allow
adequate air circulation for charger cooling (2" clearance around
entire charger recommended).
• Do not store flammable items near charger.
Page 6
SP00181
Owner's Manual 1/13/10
Advertisement
Table of Contents
