4.11.13 Programming Midi Stops - Johannus SWEELINCK 17 User Manual

4.11.13 Programming MIDI stops

24
When the General Crescendo is not activated, the CR:-- message is on the
display.
1. Press the CR piston to activate the General Crescendo. The display
indicates which step has been set.
Change the General Crescendo
The default set stop combinations of the crescendo steps can be changed
and saved in the memory.
Only step 0 cannot be changed.
1. First press the CR piston and then the MENU piston.
2. Use the - and + pistons to select the step to be changed.
3. Set the desired registration for the step.
4. Press the SET piston.
5. Select another step to be changed, if desired.
6. Press the MENU piston to switch off the programming function.
7. Press the CR piston to switch off the General Crescendo function.
MIDI is a protocol for communication between the organ and other devices,
such as:
PC
Sound Module
Other musical instruments
With the programmable MIDI stops, you can control any module voice
through any MIDI channel.
Connecting external device
1. Connect the cable of the external device to the connector MIDI MOD.
2. Put the output cables into AUX IN to hear the MIDI voices through the
organ.
Selecting programmable MIDI stop
1. Open the memory lock by turning the key. The SET piston lightens up.
2. Press the desired MIDI stop piston.
3. Use the - and + pistons to select a Memory bank.
4. Press the SET piston.
5. Press the piston of the desired memory location (Generals, Divisionals
or Hand Combination).