Table of Contents
Advertisement
4. Press and hold down the WPS button on your AP (some router/AP will have a virtual button on
their management software instead). Refer to your AP's documentation for details using its WPS
functions
When WPS configuration is done, wireless connectivity will be established and the security
encryption, such as WEP or WPA-PSK, will be synchronized with the AP.
As for IP setting, the camera's use of DHCP or static IP is determined by your configuration on the
network camera via the web- based configuration of firmware. The camera's default is DHCP for
the
.
VIP2P1N
Notes:
1. WPS may not work if your AP is configured with a "hidden" SSID.
2. If any WPS-enabled AP is not detected, the camera will search APs for 60 seconds after
pressing the WPS button, and if the camera still can not detect an AP after 1 minute, the
wireless setup will be cancelled.
3. If a camera is assigned with a fixed IP outside the AP's network segment, wireless setup will fail.
4. A wired connection always has a higher priority, and hence wireless setup will not take effect
when the RJ45 LAN port is connected.
8
Advertisement
Table of Contents
