Mitsubishi Electric PENTIUM PCL5100 User Manual page 6

BIOS upgrade and recovery (PL11, PL3)
Power Mode light colour (PL201)
P C L 5 1 0 0 f e a t u r e s a n d u p g r a d e s
These jumpers should not normally be changed except by a service
engineer or at the direction of a service engineer.
CMOS is cleared by moving the PL11 jumper to the 2-3 position
for a few moments while the system is turned off, then returning it
to the normal 1-2 position.
Clearing CMOS
CMOS battery connected (default)
CMOS battery disconnected
BIOS reprogramming
Enabled (default)
Disabled
Normally, the Power Mode light is [red] when the system is in Off
mode. If you move the jumper on block PL201 to pins 2-3 (
the light is extinguished in Off mode.
PL11
1-2
2-3
PL3
1-2 (
PROG
2-3 ( )
DIS
PCL5100 USER GUIDE
)
)
OFF
5