Download Print this page

Motherboard Jumper Settings - Mitsubishi Electric PENTIUM PCL5100 User Manual

Pentium and pentium mmx processor ready
Hide thumbs

Advertisement

Motherboard jumper settings

Processor voltage and bus speed (PL19, PL18)
P C L 5 1 0 0 f e a t u r e s a n d u p g r a d e s
There are only a few jumpers on the motherboard that you may
need to alter. All others are set at the factory and should not be
changed.
On the motherboard, pin 1 of each jumper block is indicated by a
small triangular marking.
CAUTION
Do not change these jumpers unless you have upgraded the processor. If
they are set incorrectly the processor and other vital motherboard
components could be destroyed.
The BF0 and BF1 jumpers on jumper block PL19 may be fitted in
the High ("1") or Low ("0") position; the FS, PW2, PW1 and
PW0 jumpers may simply be either fitted across both pins ("In") or
not ("Out"). See the table on the next page for the correct
configurations.
For Pentium processors only, two jumpers must also be fitted on
PL18. These jumpers must not be fitted for Pentium/MMX
processors.
PL19
PCL5100 USER GUIDE
PL 18
3

Advertisement

loading

  Related Manuals for Mitsubishi Electric PENTIUM PCL5100