Advertisement
Advertisement
Table of Contents
Related Manuals for Trelawny 735.7075
Summary of Contents for Trelawny 735.7075
- Page 1 7” ANGLE GRINDER OPERATION & MAINTENANCE...
-
Page 2: Operation
Grinder, please do not hesitate to air intake a teaspoonful (5ml) of a suitable Ensure tools maintained contact your local Trelawny dealer or pneumatic motor lubricating oil preferably according to our recommendations, and agent. We always welcome feedback incorporating a rust inhibitor. -
Page 3: Putting Into Service
OPERATION Putting into service Do not apply excessive pressure as this Grip splined end of the rotor (24) carefully will reduce the cutting efficiency. so as not to damage the splines and Remove plastic bung from air inlet using Apply light loads and allow the wheel to unscrew [left hand thread] the governor a pair of pliers. -
Page 4: Maintenance
MAINTENANCE For the motor make sure that the end This machine has a speed controller or Reassembly governor, parts (21), (28), (42), (44), (45) plates that abut the cylinder are free from Clean all parts and examine for wear. and (46). burrs and sharp edges and if necessary The correct setting of this speed controller lap on a flat fine grade of abrasive paper. -
Page 5: Safety Rules
SAFETY RULES Safety Rules for a Grinder 1) Read all the instructions before using this tool. All operators must be fully trained in its use and aware of these safety rules. 2) Do not exceed the maximum working air pressure. 3) Use personal protective safety equipment. -
Page 6: Parts List
© Copyright 2013, Trelawny SPT Limited, CV31 1XT. UK All rights reserved. Any unauthorised use or copying of the contents or part thereof is prohibited. This applies to trademarks, model denominations, part numbers and drawings.
Need help?
Do you have a question about the 735.7075 and is the answer not in the manual?
Questions and answers