Install Batteries In Wireless Devices; Link All Devices To Wireless Network; Start Wireless Setup - Honeywell TL9160AR Installation Manual

2 Install batteries in wireless devices

Thermostat
Install 2 AA alkaline
batteries

3 Link all devices to wireless network

Start wireless setup

Press the EIM Connect button on the antenna to place it in wireless setup. When the
amber light changes to a green flashing light, you can begin to link devices to the wireless
network (see pages 8-11).
If the amber light changes to a red light
instead, there is another EIM currently in
wireless setup. Press the Connect button on
the other EIM to exit its wireless setup.
If the green flashing light disappears (after
a delay of 15 minutes) before you have time
to link all your devices, press the connect
button again.
EConnect™ Wireless Thermostat Kit TL9160AR
Remote control
(optional)
Install 3 AA alkaline
batteries
* Flashing green: Ready for connection
7
Outdoor air sensor
Install 2 AA lithium
Steady green: Connection established
Steady red: Connection failure
(optional)
batteries
Connect button
Connect LED *
69-2474EFS—01