Mitsubishi MSY-A24NA Operating Instructions Manual page 9

PREPARATION BEFORE OPERATION
Remote controller
How to set the batteries and the current time
1
Remove the front lid and insert batteries.
Then reattach the front lid.
Insert the minus pole of the batteries first.
Check if the polarity of the batteries is correct.
2
Press the RESET button.
Press using a
thin stick.
• If the RESET button is not pressed, the remote con-
troller may not operate correctly.
3
Press the CLOCK set button.
Press using a
thin stick.
4
Press the (Forward) and
ward) buttons (TIME SET buttons) to set the
current time.
HR.
• Each time the
increases by 1 minute, and each time the
ton is pressed, the set time decreases by 1 minute.
• Pressing those buttons longer increases/decreases
the set time by 10 minutes.
5
Press the CLOCK set button again and close
the front lid.
Insert the minus pole
of the batteries first.
(Back-
button is pressed, the set time
Handling of the remote controller
• The range that the signal can reach is about 20 ft. when
the remote controller is pointed at the front of the indoor
unit.
• When a button is pressed, one or two beeps will be
heard from the indoor unit. If no sound is heard, operate
again.
• Use the remote controller carefully.
If it is dropped, thrown or it gets wet, the remote control-
ler may not operate.
• Since the display on the remote controller is made of
liquid crystal (glass), it may not light up if it is damaged
from falling.
• Refer to page 12 when the indoor unit does not respond
to the remote control signal.
When installing on a wall, etc.
• Install the remote controller holder in a position where
the signal reception sound (beep) can be heard from
the indoor unit when the
How to install/remove the remote controller
Installing :Insert the remote controller downward.
Removing :Pull it up.
Remote control-
ler holder
Dry-cell batteries
I Reference for replacing batteries
Replace the batteries with new AAA alkaline batteries
in the following cases:
·
When the indoor unit does not respond to the remote
control signal.
·
When the display on the remote controller becomes dim.
·
When a button of the remote controller is pressed, all
displays appear on the screen, and then disappear im-
mediately.
Do not use manganese batteries. The remote controller
could malfunction.
• The service life of an alkaline battery is about 1 year.
However, a battery whose time limit is approaching may
be exhausted soon. The recommended usable time limit
is indicated (month/year) on the bottom of the battery.
• To prevent liquid leakage, take out all batteries when
the remote controller is not going to be used for a long
time.
CAUTION:
If liquid from the batteries gets onto your skin or
but-
clothes, wash it well with clean water.
If liquid from the batteries gets into your eyes, wash
them well with clean water and consult a doctor at
once.
• Do not use rechargeable batteries.
• Replace the 2 batteries with new ones of the same type.
• Dispose of exhausted batteries in the correct manner.
ON/OFF
button is pressed.