1-12-5. Delayed Start Programming; 1-12-6. Cancelling Or Changing A Programme - Bush DW12-TFE3 Series Service Manual

Service Manual
Issue
Model No: DW12-TFE3 Series
Rev.
1-12-5. Delayed start programming
You can delay the start of a programme in increments of 1 hour up to 24 hours.
--Close the door after loading the appliance.
--Switch dishwasher ON.
--Immediately press the Delayed Start button "F". The delayed start indicator "E" blinks and the
time-remaining indicator "G" changes to " ".
--Press the Delayed Start button for 2 seconds until the numerical display shows the required delay.
--To cancel the time delay setting, press the Delayed Start button until the delayed start indicator "E"
goes out.
--Rotate programme dial "J" to select the desired programme.
--After 3 seconds the delayed start indicator "E" blinks. The time-remaining indicator "G" will also
blink. The programme will start when both lights fade.
1-12-6. Cancelling or Changing a programme
--A cycle that is underway can be modified if it has only been running for a short time. Otherwise, the
detergent may have already been used and the appliance may have already drained the wash water.
If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Adding
Detergent").
--To modify a cycle that is already underway, follow the instructions contained in the paragraph
entitled "Reset function" and select the programme you require (see the paragraph entitled
"Switching the dishwasher ON").
Notice:
If the cancelled programme has already used the detergent and drained the wash water, the
detergent dispenser must be refilled.
1-12-7. 3 in 1 function
When using "3 in 1" combination products, the rinse-aid and salt indicator lights are no longer
relevant. It may be helpful to select the lowest possible setting for water hardness.
If you decide to switch to using a standard detergent system we advise you to:
--Refill both the salt and rinse aid compartments.
--Switch the water hardness setting to the highest possible position and run for three normal cycles
with the appliance left empty.
--Readjust the water hardness setting again according to the conditions of your region.
Page 29 of 49