3 Get started
Always follow the instructions in this chapter in
sequence.
Prepare the remote control
Note
•
Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
•
Battery contains chemical substances, so it should be
disposed of properly.
•
If you are not going to use the remote control for a
long time, remove the battery.
To install the remote control battery:
1
Open the battery compartment.
2
Insert one AAA battery with correct
polarity (+/-) as indicated.
3
Close the battery compartment.
Prepare radio antenna
For better radio reception, fully extend and
adjust the position of the antenna.
Note
•
To prevent interference, position the antenna as far as
possible from any other radiation sources.
Connect power
Caution
•
Risk of product damage! Make sure that the power
voltage corresponds to the voltage printed on the back
or underside of the clock radio.
•
Risk of electric shock! When you unplug the AC plug,
always pull the plug from the socket. Never pull the
cord.
1
Select an adapter plug converter and fix it
to the adapter.
2
Connect the power adapter to:
the DC IN socket on the back of the
•
radio, and
•
the wall socket.
EN
7