Usb-av-player for bmw professional navigation systems without idrive (19 pages)
Summary of Contents for Caraudio-Systems c.LOGiC C2-MFD2
Page 1
c.LOGiC-Interface C2-MFD2 For navigation systems Volkswagen MFD2/RNS2 Skoda Nexus Only for vehicles WITHOUT factory rear-view camera Product features • full plug and play multimedia interface • 2 AV-inputs with separate IR-control channel • control of after-market devices, e.g. DVB-T tuner, DVD-player, DVD-changer, … •...
Contents 1. Prior to Installation 1.1. Delivery contents 1.2. Check compatibility of vehicle and accessories 1.3. Setting the dip switches of the CAN-box TV-400 1.4. Setting the dip switches of the Interface-box C2C-M200 1.4.1. Automatic switching to rear-view camera 1.4.2. Deactivating c.LOGiC AV2-input 2.
Legal Information By law, watching moving pictures while driving is prohibited, the driver must not be distracted. We do not accept any liability for material damage or personal injury resulting, directly or indirectly, from installation or operation of this product. This product should only be used while standing or to display fixed menus or rear-view-camera video when the vehicle is moving, for example the MP3 menu for DVD upgrades.
1.2. Check compatibility of vehicle and accessories Requirements Vehicle Volkswagen and Skoda Navigation MFD2/RNS2 or Nexus navigation Limitations Factory-TV-tuner Must NOT be installed. 1.3. Setting the dip switches of the CAN-box TV-400 All vehicles dip 1 ON, dip 2 OFF, dip 3 OFF 1.4.
3. Installation Switch off ignition and disconnect the vehicle’s battery! If according to factory rules disconnecting the battery has to be avoided, it is usually sufficient to put the vehicle is sleep-mode. In case the sleep-mode does not show success, disconnect the battery with a resistor lead.
3.2. Connections to head-unit Remove the head-unit from the dash-board. Transfer female Quadlock connector from the back of the head-unit to male Quadlock connector of harness C3C-VW02. Plug female Quadlock connector of C3C-VW02 into male Quadlock socket of head-unit. Plug female 18pin AMP-connector of C3C-VW02 into male 18pin AMP-socket of head-unit.
3.3. Connecting peripheral devices It is possible to connect up to 2 after-market AV-sources, after-market rear-view camera and rear-seat-entertainment to the c.LOGiC interface. Before final installation of the peripheral devices, we recommend to test-run the c.LOGiC functions to detect incompatibility of vehicle, navigation, factory accessories or peripheral devices as soon as possible.
3.3.1. AV-source(s) The c.LOGiC interface has the possibility to connect and remotely control by navigation buttons up to 2 pre-programmed devices. The device list in the device control table (Appendix A) shows the pre-programmed remote channels and the related IR-remote cables STA-xxx which must be ordered separately for the control of the device.
3.3.2. Installing AV-source’s IR-sensor additionally Additionally to the control via OEM navigation, it is possible to install the original IR-sensor of a connected device. By using the respective Y-adapter (e.g. STA-Y35MM or STA-RJ12) for the IR-Port of the connected device, the controls of navigation AND device’s IR-sensor can be connected and used simultaneously.
3.3.4. After-market rear-seat-entertainment Using RCA-cables, connect the rear-seat-entertainment to the female RCA-connector VIDEO OUT of Interface-box C2C-M200. Note: As the output is a full output, not shared with the video signal for the navigation system, splitting the video with an RCA Y-cable might give a good enough picture for two rear-seat-entertainment monitors.
4.3. Switching between AV1 and AV2 After selecting the c.LOGiC as current AV source, push the right knob for 3 seconds to switch between AV1 and AV2. Repeat to switch back. Note: If AV2 is deactivated (see chapter chapter Deactivating c.LOGiC AV2 input), it is not possible to switch to the c.LOGiC’s AV2.
Page 13
Button assignment table c.LOGiC MFD2/RNS2/Nexus Head- DVB-T Interner USB DVD-player DVD- iPod®-control Analog-tuner unit Tuner changer button POWER PLAY PLAY PLAY/PAUSE SCAN MEDIA EJECT MODE VOL+ SHUFFLE INFO VOL- TITLE TITLE REPEAT DISPLAY SCAN ZOOM ZOOM DISC SCAN MENU SETUP SETUP SETUP LIGHT...
Temperature range -30°C to +80°C Weight 202g Measurements (box only) B x H x T 90 x 30 x 105 mm 6. Technical Support Caraudio-Systems Vertriebs GmbH NavLinkz GmbH manufacturer/distribution corporate sales/tech dealer-support Rheinhorststr. 22 Eurotec-Ring 45 D-67071 Ludwigshafen am Rhein...
Need help?
Do you have a question about the c.LOGiC C2-MFD2 and is the answer not in the manual?
Questions and answers