Insert The Battery - UTStarcom F1000 Series Quick Start Manual

2

Insert the Battery

IMPORTANT: Use ONLY the UTStarcom
rechargeable battery supplied with your
new phone!
1. Remove battery from packaging.
2. Remove the battery cover. With the
back of the phone facing you, press the
battery cover release button and lift the
cover off in the direction of the arrow.
3. Install the battery. Connect the cord of the
new battery by firmly inserting the
connector into its place. Do not reverse
the connector.
4. Replace the battery cover until it clicks
into place.
The F1000 comes partially charged, so the
phone can be used immediately. Please
refer to the "Charge the Battery" section of
the F1000 Handbook for instructions on fully
charging the battery.
Page 02
Black
Yellow
Red
2
3
4