Identification Of Controls - Sanyo LCD-26XR9DA Instruction Manual

Main Unit (front/side view)
1 2
3
Main Unit (back view)
3
AC IN
AUDIO D-Sub
S/PDIF HDMI 1 HDMI 2 PC IN
4 5 6

Identification of Controls

1. Power indicator
2. Remote sensor
3. Power Switch
4. CH+
5. VOL+
6. MENU
4
7. SOURCE
5
8. POWER
6
SOURCE
7
8
1. Headphone: Connect headphones to this jack.
2. HDMI3: Connect an HDMI device to this jack.
3. AC IN: Plug the AC cord into this jack and into a power outlet.
1
4. S/PDIF: Connect a digital sound system to this jack.
2
5. HDMI1/HDMI2: Connect HDMI devices to these jacks.
6. PC IN D-SUB/AUDIO: Connect a computer to these jacks.
7. COMPONENT IN 1/2 : Connect component video devices to
8. AV INPUT: Connect an AV device to these jacks.
9. AV OUTPUT: Connect a VCR to these jacks to record programs.
10. RF: Connect an antenna or cable TV to this jack.
VIDEO AUDIO
Y AUDIO 2
AV OUT
1
AUDIO
VIDEO
AUDIO
COMPONENT IN
AV IN
7 8
Lights blue when in operating mode.
Lights red when in standby mode.
Receives signals from the remote control. Do not block.
/-
Press these two buttons to directly change the TV channel;
In menu operations, these buttons serve as up/down buttons.
/–
Press the VOL+ or VOL– button to directly increase or decrease
the sound volume level;
In menu operations, these buttons serve as right/left buttons.
Press this button to access the main menu screen.
To access SOURCE menu
Press this button to turn the unit ON from STANDBY mode.
Press it again to turn the set back to STANDBY.
these jacks.
11. RS-232: For service only. Do not use.
RF RS-232
9 10 11
7