Operation - Worx WG307 Manual

IMPORTANT: Use only the
recommended oil to avoid damage
to the Jawsaw
old oil. Use of non approved oil will
invalidate the warranty.
CHECKING THE AUTOMATIC OILER
The Jawsaw uses a much lower chain speed
TM
than a conventional chainsaw so it needs
much less oil.
However it is very important that it always has
oil.
Check the Oil Level Window (5) and refill as
necessary.
During operation, periodically check the Saw
Chain (11) and Guide Bar (10). A slight oil
presence should be visible. If the chain and
bar appear completely dry, then remove the
bar and chain (see previous section) to ensure
the bar oil hole is not blocked.
If the oil hole is clear, there is oil in the tank
and still no oiling of the chain is visible –
contact Worx customer service.
WARNING: Do not push the rear
handle repeatedly when the saw is
not cutting. The oil will be bumped
out when pushing the handle whether
the motor runs or not.
26

OPERATION

PREPARE YOUR JAWSAW
WARNING!
• Read and understand all instructions.
Failure to follow all instructions listed
may result in electric shock, fire and/
or serious personal injury.
• Sharp moving blade. To prevent
accidental operation, ensure that
the tool is disconnected from the
power source before performing the
following operations, failure to do this
could result in serious personal injury.
CAUTION: Sharp moving blade.
Always wear protective gloves
when installing or removing the chain,
the Saw Chain (11) is sharp and can cut
you when it is not running.
Limbing and trimming Electric Jawsaw
. Never use recycled/
TM
FOR USE
TM
ATTACHING EXTENSION CORD
1. To prevent disconnection of appliance cord,
secure extension cord to extension cord
retainer.
2. An extension cord retainer is supplied to
reduce strain on the power cord. To use
this feature, form a loop at the end of the
extension cable and bring this through the
opening at the bottom of the Extension
Cord Retainer, then wrap the end of the
loop around the hook and pull to tighten.
(See Fig. I)
3. Keep extension cord clear of the saw and
any obstacles at all times. Do not expose
the cord to heat, oil, water, or sharp edges.
WARNING:
• Never operate a Jawsaw
damaged or improperly adjusted or
that is not completely and securely
assembled.
• Be sure that the saw chain stops
moving when the trigger switch (4)
released.
• Never adjust the guide bar or saw
when the power cord is connected.
SWITCHING ON AND OFF
The Trigger Switch (4) is locked to prevent
accidental starting.
There are two Lock Out Buttons (2), to
allow upright (cutting down from the top)
or inverted (cutting up from the bottom)
operation.
To switch on, press either Lock Out Button
with your thumb and squeeze the Trigger
Switch (See Fig J).
To switch off, just release the Trigger Switch.
CUTTING
Check oil level window (5) prior to starting and
regularly during operation. Refill oil when oil
level is low.
If operating with a newly replaced Saw Chain
(11), check the chain tension around every 10
minutes during operation.
Always hold the Front Handle (7) firmly when
cutting (See Fig. K1, K2)
1. Connect the Jawsaw
to a power outlet.
2. Use both hands to grip saw firmly. Always
that is
TM
and extension cord
TM
EN
TM