Worx WG307E Safety And Operating Manual
  1. Manuals
  2. Brands
  3. Worx Manuals
  4. Chainsaw
  5. Jawsaw WG307E
  6. Safety and operating manual

Worx WG307E Safety And Operating Manual

Limbing and trimming electric chain saw
Hide thumbs Also See for WG307E:
Table of Contents

Advertisement

Quick Links

See also: Manual
SAFETY AND OPERATING MANUAL
Limbing and Trimming
WG307E WG308E
Electric Chain Saw

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the WG307E and is the answer not in the manual?

Questions and answers

Related Manuals for Worx WG307E

Summary of Contents for Worx WG307E

  • Page 1 SAFETY AND OPERATING MANUAL Limbing and Trimming WG307E WG308E Electric Chain Saw...

  • Page 2: General Power Tool Safety Warnings

    When operating a power tool connected and properly used. Use of outdoors, use an extension cord Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 3 7. Use extreme caution when cutting brush and saplings. The slender material 5) SeRvIce may catch the saw chain and be whipped a) Have your power tool serviced by toward you or pull you off balance. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 4 Do not rely exclusively upon the safety devices built into your saw. As a jaw saw user, you should take several steps to keep your cutting jobs free from accident or injury. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 5 Wear ear protection Wear dust mask Do not expose to rain Remove plug from the mains immediately if the cable is damaged or cut. RCM approval mark Warning of danger from overhead electric-power lines Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 6 Limbing and Trimming WG307E WG308E Electric Chain Saw...

  • Page 7: Power Cord

    18. lock PIN RecePtAcle (See fig. B3) 19. oIl Bottle 20. exteNSIoN Pole (oNly foR WG308e, See fig. Z4) 21. cABle Hook Not all the accessories illustrated or described are included in standard delivery. Limbing and Trimming WG307E WG308E Electric Chain Saw...

  • Page 8: Technical Data

    We recommend that you purchase your accessories from the same store that sold you the tool. Use good quality chain oil. Use only replacement bar and chain of the same specification. Your retailer can advise the correct purchase. Limbing and Trimming WG307E WG308E Electric Chain Saw...

  • Page 9: Intended Use

    Lock the bar in the middle position by inserting the lock pin (17) found on the power cord into the lock pin receptacle (18) located under the handle (See Fig. B1-B3). Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 10 2.Disconnect the power, install the lock pin and open the chain access cover as described in the previous section. 3.Use only WORX replacement bar and chain. 4.Loosen and remove the chain tensioner bolt. 5.Lift the guide bar (10) and chain (11) out through the jaw, angling the bar to clear the two bar locating pins (d) (See Fig.
  • Page 11 (16) (See Fig. I). There is little excess chain length, therefore, the chain must be properly fitted in the bar slot to provide enough extra chain to be pulled over the drive sprocket. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 12 (see previous section) to ensure the bar oil hole is not blocked. If the oil hole is clear, there is oil in the tank and still no oiling of the chain is visible – contact Worx customer service. Limbing and Trimming...

  • Page 13: Operation

    Refill oil when oil level is low. Check newly replaced chain tension approx. every 10 minutes during operation. Always hold secondary handle firmly when cutting (See Fig. P1, P2) Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 14 Never cut two branches at once. 2.Will the branch split before it is cut through? (See Fig. R1, R2) • To prevent splitting, use the JawSaw inverted, make a small cut (less than 1/3 diameter of the Limbing and Trimming WG307E WG308E Electric Chain Saw...

  • Page 15: General Behavior

    GeNeRAl BeHAvIoR Use the JawSaw only with secure footing. Hold the JawSaw at the right-hand side of your body. (See Fig. S) The chain must be running at full speed before it Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 16 While cutting log, never hold log with your hand or leg. • While cutting log, never allow another person to hold log. • Turn off and unplug saw before moving from one place to another. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 17 Hook the shoulder strap to the Extension Pole and wrap around your shoulder. The shoulder strap can also soften the impact if the JawSaw is dropped after the completion of a cut. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 18 3m away from all power lines. (See fig. AB1-AB4) 5. Position the Jaw perpendicularly on the branch being cut. Note: Maximum cutting capacity of JawSaw is 100mm. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 19 3. Do not use the JawSaw, if: • The trigger switch or lockout is malfunctioning. • The push handle does not smoothly return under spring force. • Any other damage which affects the safety or operation is evident. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 20 A dull chain will cause undue sprocket, guide bar, chain, and motor wear. If you must force chain into wood and cutting creates only sawdust with few large chips, chain is dull. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 21 Never let any liquid get inside the tool and never immerse any part of the tool into liquid. tRANSPoRtING Always transport the tool with the guide bar and chain inside the protection guard. Limbing and Trimming WG307E WG308E Electric Chain Saw...

  • Page 22: Troubleshooting

    GUIDe BAR AND cHAIN. • Refer to cHANGING tHe • Chain installed backwards. GUIDe BAR AND cHAIN • Unit runs but does not cut. See Fig H and illustration. section. Limbing and Trimming WG307E WG308E Electric Chain Saw...
  • Page 24 Copyright © 2013, Positec. All Rights Reserved.

This manual is also suitable for:

Wg308e

Table of Contents