Stand Mode Illumination Off Time; Scanning Active Time - Datalogic PowerScan PD9530 Product Reference Manual

Enter/Exit Programming Mode
Specifies the amount of time reader illumination stays off after pulling the trigger when in
Stand Mode. The configurable range is 01 to 32 by 01 in increments of 500ms (500ms to
16 seconds). See
$CSNTM
Select Stand Mode Time Setting
This setting specifies the amount of time that the reader stays in scan ON state once the
state is entered. The range for this setting is from 1 to 255 seconds in 1-second increments.
See
page 230
$CSNET05(CR)
Scanning Active Time = 5 seconds
70

Stand Mode Illumination Off Time

in "References" for a description of this feature.
page 229
DEFAULT

Scanning Active Time

in "References" for further description of this feature.
To configure this feature, scan the ENTER/EXIT PRO-
GRAMMING MODE bar code above, then the bar code at
left followed by the digits from the Alphanumeric char-
acters in
Appendix D, Keypad
character(s). End by scanning the ENTER/EXIT bar code
again.
04 = 2 Seconds
$CSNET03(CR)
Scanning Active Time = 3 seconds
DEFAULT
$CSNET08(CR)
Scanning Active Time = 8 seconds
representing your desired
PowerScan™ PD9530