Dmx 512 Connection; Set Up; Control Panel - Evolite MOVING BEAM 5R User Manual

o DMX 512 connection
The wires must not come into contact with each other, otherwise the fixture will not work at all or properly. Please note the starting
address depends upon which controller is being used. Only use a DMX cable and 3-pin XLR-plugs and connectors in order to connect
the controller with the fixture or one fixture to another
Connection with the mains.
The earth has to be connected. The device must only be connected with an electric installation carried out in compliance with IEC
standards.

• Set up

Control panel

o
Large LCD Display with backlight
This backlighted LCD display indicates the fixture is DMX addressed, the fixture status, set up values ..etc
The display can be turned off or on "sleep" mode via the DISPLAY function in main menu.
Selection wheel
Use this wheel to navigate into menus. Press on this wheel to enter a menu and to valid a value.
MOVING BEAM 5R Manual Ver. 1.02[Texte] Page 14