Parts Not Included With Your Hood; Considerations Before Installing Hood; Parts Included With Your Hood - Thermador HNW36 Installation Instructions Manual

Parts Included with your
Hood
• Hood Canopy Assembly with
Ventilator and Light Bulbs
Installed
• Care & Use /Installation
Instructions
• Registration Card
• Filters number depends on
model and size
• Plastic Transition with
Back draft dampers
installed
• Screws and Drywall An-
chors
• 2 Mounting Hooks
• Mounting Templet
• 2 Piece Duct Cover
• 8" Starting Collar
• Contents Sheet

CONSIDERATIONS BEFORE INSTALLING HOOD

1. For the most efficient air
flow exhaust, use a straight
run or as few elbows as
possible.
CAUTION: Vent unit to
outside of building, only.
2. Use flex ducting only to
connect rigid duct directly to
transitions.
3. COLD WEATHER installa-
tions should have an addi-
tional backdraft damper
installed to minimize
backward cold air flow and a
nonmetallic thermal break
to minimize conduction of
outside temperatures as
part of the ductwork. The
damper should be on the
Parts Not Included with
your Hood
• HDTR8 Metal Transition if
required.
• Duct Tape
• 1/2" Conduit
• Wire Nuts
• Plywood Wall Mounting Block
cold air side of the thermal
break. The break should be as
close as possible to where the
ducting enters the heated
portion of the house.
4. Hood installation height above
cooktop is the users preference.
The closer the hood is to the
cooktop the more efficient it will
be in capturing of cooking odors,
grease and smoke. Thermador
recommends the hood be in-
stalled 30-36" above the
countertop. The lower height
may be inconvenient for tall
people and large cooking vessels.
Check your ceiling height and
the hood height maximum before
you select your hood.
Page 5