IMPORTANT SAFETY INSTRUCTIONS WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: CAUTION: FOR VENTILATION USE ONLY. DO NOT USE TO EXHAUST HAZARDOUS OR EXPLOSIVE MATERIALS OR VAPOR. 1. Use this unit only in the manner intended by the manufacturer.
Page 3
LES INSTRUCTIONS DE SÉCURITÉ IMPORTANTES AVERTISSEMENT - POUR RÉDUIRE LE RISQUE D’INCENDIE, DE CHOC ÉLECTRIQUE, OU DE LA BLESSURE AUX PERSONNES, OBSERVER LE SUIVANT: ATTENTION: SEULEMENT POUR L’UTILISATION D’AÉRATION. NE PAS L’UTILISER POUR ÉPUISER LA VAPEUR OU LES MATIÈRES EXPLOSIVES OU DANGEREUSES.
Page 4
MODEL: A. Motor OFF button B. ON button and motor speed selection button 1, 2, 3, 1,... C. Speed 1LED D. Speed 2 LED E. Speed 3 LED F. Timer LED G. Timer. If the motor is off while the ti- mer is pressed the motor will run at speed 3 for 20 minutes then stop.
Page 5
Make sure the lights are cool. If new lights do not opera- te verify lights are inserted correctly before calling service. Replace Lights For HNW • Using a flat edge from a screwdriver or equivalent tool pry loose the lens cover as shown in Figure 3.
Page 6
Contact the Factory Authorized Service Agent in your area. • Contact the Dealership where you purchased the appliance. • Call the Thermador Customer Support Call Center at 800-735-4328. • Write to us at: Thermador 5551 McFadden Avenue, Hunington Beach, CA 92649. Page 6...
Need help?
Do you have a question about the HNW and is the answer not in the manual?
Questions and answers