Considerations Before Installing Hood; Parts Included With Your Hood - Thermador H Installation Instructions Manual

Parts included with your Hood:

Hood Canopy Assembly
Rough-in Plate
* Transition/Damper for ducting
Mounting Screws (8, #10 x 1") - may
not need all screws (depending
on hood size)
Installation Instructions
Care & Use Manual
Registration Card
Filters (3 or 4 depending on hood size)
Hex nuts (10 pieces)
Blower Mounting Bracket
To be purchased separately:
• Ventilator: choose one of
following:
* VM410 – 400CFM, integral
ventilator.
VTN600Q – 600 CFM, integral
ventilator.
VTR600R – 600 CFM, remote
ventilator.
VTR1000Q – 1000CFM, remote
ventilator.
• H and HT models require Transi-
tion HTR8 or HTR10.
• For integral ventilator installations,
choose one of the following ex-
haust outlets:
– RJ310 (roof outlet)
– WC310 (wall outlet)
– WC8
– WC10

CONSIDERATIONS BEFORE INSTALLING HOOD

1. For efficient air flow exhaust, use a
straight run or as few elbows as
possible.
2. Do not use flex ducting.
* NOTE: The 19-11-943 (equiva-
lent to VM410) Ventilator and
Transition are included with all
HB Model hoods.
the • Halogen Bulbs (2), size R20, 50
watt maximum.
• Duct Tape, 2" wide
• Wall Anchors (if needed)
• 1/2"Diameter Conduit
• Keep Hot Shelf Accessory-KHS
(Optional)
• Wire Nuts
• Keep hot lamps (2) Size R40
250W maximum (H/HT Hoods
only)
3. COLD WEATHER installations
should have an additional backdraft
damper installed to minimize back-
ward cold air flow and a non-
metallic thermal break to mini-
mize conduction of outside tem-
peratures as part of the ductwork.
PAGE 2
• Tools Needed:
Phillips Screw Driver
3/8" Hex Socket Driver
1-1/2" Drill bit (Wood)
Electric Drill
Hammer
Pencil
Level
Saber Saw
The damper should be on the cold
air side of the thermal break. The
break should be as close as pos-
sible to the location where the
ducting enters the heated portion
of the house.