Safety Regulations - Maggi EVOLUTION 1000 User And Maintenance Manual

2.1 Safety regulations

Read the usage and maintenance manual carefully before proceeding with start-up, use or maintenance
−
or any type of machine operation.
Strictly abide by all warning, ranger and caution information container in the manual and the safety signs
−
applied directly to the machine.
The operator shall be in full possession of all the requirements established for the use
−
of this type of machine.
The safety devices protecting the operator shall always be installed and in working order.
−
Always use the personal protective equipment provided for in the laws in force on safety at work.
−
Do not wear bracelets, rings necklaces, etc. as they can cause serious accidents; before starting work,
−
remove anything that can cause this type of risk.
Before proceeding with machining, examine the work area in search of dangerous conditions; insure that
−
foreign bodies have not been forgotten in or on the machine.
Carry out the operation cycle start-up sequence only as recommended.
−
Do not access the machine's area of operation while it is running.
−
Do not place your hands near or inside moving or energised parts of the machine or in the electrical
−
cabinet.
Do not work in the dark; use all available lights and insure that they are in working order.
−
Concentrate properly and be very cautious before performing any action.
−
Never leaves the machine unmanned when it is running.
−
Always have a clear view of the entire work area.
−
Though the electrical panel features its own protection system, the operator shall not access the panel.
−
Warn those in charge of maintenance of any running irregularities of parts or systems.
−
2.2 Safety warnings for maintenance
Before performing any maintenance and/or cleaning the machine, cut off all electrical and pneumatic
−
supply.
Maintenance shall be performed by qualified personnel.
−
Before performing any maintenance or lubrication, stop the machine using the procedures describing in
−
the manual.
Each time units are removed or installed, ensure that they are supported by lifting devices suitable for
−
the load to be lifted.
Immediately transfers the load onto proper means of support or trestles.
−
Do not attempt to climb on or off the machine while it is moving.
−
Never use petrol, solvents or flammable fluids to clean parts. Use commercial and authorised not flam-
−
mable and not toxic detergents.
Performance all maintenance and repair carefully, according to the instructions contained in this manual.
−
Always use personal protective equipment.
−
Use electrical tools that comply with the safety regulations in force.
−
Before starting the machine, ensure that there is no one performing maintenance on it.
−
Do not work under or near a kinematics motion if it is not properly supported and locked.
−
Before cleaning, repairing or performing any other type of operation on the machine, always set the start
−
selector to the lock position.
Wear protective goggles with side screens.
−
Before removing any guard, stop the machine completely by cutting of power to the electrical and pneu-
−
matic supply line, making sure that no parts are moving.
The machine shall be used in accordance with is designated use.
−
The machine shall always be used in compliance with the safety regulations in force in each country.
−
Page 14