Temperature Alert; Low Battery Indication; Specifications - Mebus 10394 Owner's Manual

TEMPERATURE ALERT

Press "ALERT" to turn temperature alert on and off.
Hold "ALERT" 3 seconds to enter the alert setting mode. The indoor channel and the Upper &
Lower pointers flash.
Press " +, -" to select the indoor or Ch1, 2, 3 and press "ALERT" to confirm the channel. The
Upper pointer and temperature will flash, enter the desired upper limit with the " +, - " buttons,
press "ALERT" to confirm and go to the lower limit setting.
The Lower pointer and temperature will flash, enter the desired lower limit with " + , -" buttons,
press "ALERT" to confirm and exit.
Each setting cycle will allow setting one channel for the temperature alarm. The unit allows to
enter temperature alert for the indoor channel and all of the Channel 1, 2, 3.
When temperature hits the limit of the preset, the Upper & Lower pointers and the
temperature of the respective channel will flash, Press any keys to stop the alarm.

LOW BATTERY INDICATION

Low battery indication is available for the home unit itself and all of the 3 remote channels.
Replace the batteries and follow the setup procedure as mentioned in this instruction manual.
BATERY DISPOSAL
Replace only with the same or equivalent type recommended by the manufacturer.
Please disposal of old, defective batteries in an environmentally friendly manner in
accordance with the relevant legislation.

SPECIFICATIONS

Range of temperature measurement:
Indoor unit
Remote sensor
Channel
Transmission
Resolution
Clock
Power
W182 SNPMEB.indd 18
: 0 C to + 50 C (+32 F to +122 F)
: -20 C to +60 C (-4 F to +140 F)
: max. 3 remote sensors
: max. 30M (100 ft.) open area, RF434 MHz
: 0.1 degree for temperature
: DCF77 Radio-controlled
: 4.5V AC/DC adapter, AA x 2 pcs for main unit
AAA x 2 pcs for remote sensor
18
3/15/07 4:23:00 PM