Pipeline SC User Manual page 59

Control
Timecode
Timecode Sources
(select one)
SNTP Server
Buttons
Save Changes
Default
Reboot
Soft Reboot
74-0085-05
Description
Select Auto, RS422, SDI, Channel 1 (Pipeline Quad only) or SNTP. In
Auto mode, Pipeline selects the time code source by priority
– auto mode clock source options
mode clock source options on page
For Pipeline Quad channels 2, 3, and 4, you can select Channel 1 as the
source. Channel 1 itself must be set to an external source.
Note: Auto selection is ignored by the Pipeline Control application, whose
schedule settings override those of the selected Pipeline.
When SNTP is selected as a time code source, edit field for entry of
SNTP server IP address.
If another user is connected and processing media with this Pipeline,
using these buttons will interrupt the process, and it must be re-started.
Click to update the Pipeline with the new settings. If you change the IP
address (by any means – returning to self-assigned, enabling DHCP, or
assigning a static address), in about 30 seconds, Pipeline Direct displays
an error: "Unable to communicate with Pipeline". Click OK, then
reconnect to the Pipeline using the new IP address.
Return settings to default.
This reboot performs a hardware-level reset, which disconnects Pipeline
from any client which may attached without warning. Click to reboot the
Pipeline if you change the password, to log on using the new password.
You do not need to reboot when changing IP settings.
This reboot resets the Pipeline without disconnecting from an attached
client. In cases where the Pipeline is non-responsive, click Software
Reboot to clear the problem and continue. However, performing a soft
reboot during streaming will interrupt the stream.
Using the Configure Panel
Pipeline User's Guide
and Pipeline Quad and HD Dual– auto
105).
43
(Pipeline SC