Table of Contents
Advertisement
To Load the Status Monitor from the DOS Prompt
Type the following at the DOS prompt to display the Status Monitor
screen:
1
Change to the directory you created under "Installing DOS
Printing Utilities" on page 4-41.
Type: cd c:\mltdos
• If you used the directory name we showed in our installation
example, type in the command exactly as shown above. If
you used a different directory name, change mltdos to the
name you used.
2
Type the following command at the DOS prompt.
Type: rep
To Remove the Status Monitor from Memory
Type the following at the DOS prompt:
Rep /d
Note
You should use the above step to remove the Status Monitor from
memory if the Status Monitor is interfering with one of your other
software applications or if you need to free up the memory used by
the Status Monitor.
EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500
DOS Printing Utilities
4-43
Advertisement
Table of Contents
