Table of Contents
Advertisement
continued from page 5.
TO REPLACE CARBON FILTER (unit may be
operated with or without the carbon filter). The
carbon filter is a final 'polishing' filter for the water
purifier. Omit carbon filter if purified water is to be
used in an autoclave.
1. Remove the lid from the carafe.
2. Remove the carbon compartment cover by
pulling on tabs.
3. Remove the used carbon filter and discard.
Do not reuse carbon filter.
4. Rinse the inside of the carbon compartment
with water.
5. Remove carbon filter from plastic bag and
rinse under purified water for 30 seconds, so
that it is wet on all surfaces.
6. Put new carbon filter in carbon compartment.
Be sure carbon is evenly distributed within
pouch.
7. Replace carafe onto the base unit.
8. On model EWS-EU800/230, be sure to reset
the 'Filter Status Bar' by pressing and holding
the delay button for 7 seconds.
9. The next time you make purified water,
discard the first batch of water which may
have small, harmless carbon fines in it.
NOTE: The physiological effects of the operation of this appliance, beneficial or otherwise, have not been
investigated by Underwriters Laboratories.
independent laboratory.
NOT MAKING ANY
PURIFIED WATER
1. Purifier power cord
not
plugged
electrical outlet.
2. No
power
electrical outlet
3. Kettle not plugged
into base unit.
4. Did not press reset
or start button to start
cycle.
5. Did not fill the kettle
with tap water.
6. Carafe
is
not
place.
*Model EWS-EU800/230 only
CARE AND CLEANING OF YOUR WATER PURIFIER
TROUBLE SHOOTING CHECK LIST
NOT MAKING ENOUGH
PURIFIED WATER
EACH BATCH
1. Did not fill tank with
into
water to the max. fill line.
to
2. Carafe
is
correct position.
3. Kettle cover is not
locked into position.
4. Kettle
bottom
residue build up.
in
See Product Data Sheet for test data obtained from an
FLASHING INDICATOR
1. Carafe
display indicates carafe
is not in position.*
not
in
2. Flashing
indicator light indicates
kettle is not in position.*
3. Filter
display
indicates
needs changing.*
has
4. If kettle is in position
then
heating
may have failed.*
6
WATER LEAKS
flashing
in
1. Water receptacle in
carafe cover is not open
red
2. Carafe cover is not in
place.
flashing
in
3. Carafe
filter
place.
4. Kettle seal is split or
element
damaged.
replacement.
5. Unit is not on a level
surface.
is
not
in
Will require
Advertisement
Table of Contents
