To Make The Settings On The Controller Side; Ip Address Setting - Minolta CN3101e User Manual

18
4. Settings Required for Network Printing
4.2

To Make the Settings on the Controller Side

Network settings on the controller side may be made either from the copier control
panel or through PageScope Light used on a PC connected to the network. Use of
PageScope Light allows detailed settings that cannot be made from the copier
control panel to be made. For the details of PageScope Light, see "Appendix B.
How to Use PageScope Light."
To use PageScope Light, it is necessary to first set the IP address by following the
procedure given below.

IP Address Setting

1. On the control panel of the copier, select "Utility" – "Admin. Mode" and then
enter the password.
2. Select "Network set" – "Common Setting" – "TCP/IP" to open the "TCP/IP"
screen.
3. Make the following settings:
IP Address
Subnet Mask
Gateway Address
Check with the network administrator on these three items in advance.
4. Turn OFF the Power Switch OFF of the copier.
Turn the Power Switch ON again, then the settings are effective.
p.138
: Set the IP address of the controller.
: Set the subnet mask for the network to be
connected.
: Set the default gateway address for the network to
be connected.
4334P152CA