Engine - Branson 6640C Operator's Manual

TROUBLESHOOTING
• If the tractor is not working properly, stop the engine and carry out an inspection based on the following table.

ENGINE

Situation
The motor does not start
when the main switch is
turned to START.
The motor starts, but the
engine does not start.
6640C OPERATORS MANUAL (012612).indd 155
Inspection item
Are you depressing the clutch?
Is the battery solution low?
Is the battery discharged?
Is the PTO ON/OFF switch is turned on?
Is the battery terminal loosened or corroded?
Is the main fuse burnt out?
Is the key switch broken?
Is the starting motor defective?
Is the fuel tank empty?
Is the fuel mixed with air?
Does the engine run only when the reducer le-
ver is pulled?
Depress the clutch fully and turn the main
switch to START
Fill the battery solution and fully charge the
battery.
Turn off PTO ON/OFF switch.
Clean and tighten the terminals. Apply
grease to avoid rust
Replace the fuse
Contact the dealer for repair or replacement.
Contact the dealer for repair or replacement.
Fill up the fuel tank and drain the air.
Drain the air from the fuel.
Charge the battery.
• • •
155
Solution
1/30/2012 2:31:10 PM