Sony MEX-N6001BD Operating Instructions Manual page 25

The connected BLUETOOTH audio device cannot
be controlled.
 Check that the connected BLUETOOTH audio
device supports AVRCP.
Some functions do not work.
 Check if the connecting device supports the
functions in question.
A call is answered unintentionally.
 The connecting phone is set to answer a call
automatically.
Pairing failed due to time out.
 Depending on the connecting device, the time
limit for pairing may be short.
 Try completing the pairing within the time.
BLUETOOTH function cannot operate.
 Turn off the unit by pressing OFF for more than 2
seconds, then turn the unit on again.
No sound is output from the car speakers during
handsfree call.
 If the sound is output from the cellular phone, set
the cellular phone to output the sound from the
car speakers.
Application name is mismatched with the actual
application in App Remote.
 Launch the application again from the "App
Remote" application.
While running the "App Remote" application via
BLUETOOTH, the display automatically switches
to [BT AUDIO].
 The "App Remote" application or BLUETOOTH
function has failed.
 Run the application again.
Error displays/Messages
ERROR
 The disc is dirty or inserted upside down.
 Clean or insert the disc correctly.
 A blank disc has been inserted.
 The disc cannot play due to a problem.
 Insert another disc.
 USB device was not automatically recognized.
 Connect it again.
 Press  to remove the disc.
HUB NO SUPRT (hubs not supported)
 USB hub is not supported on this unit.
IPD STOP (iPod stop)
 When repeat play is not set, playback of the last
track in album finished.
The music application in the iPod/iPhone is
terminated.
 Press PAUSE to start playback again.
NO AF (no alternative frequencies)
 There is no alternative frequency for the current
station.
 Press SEEK +/– while the program service name
is flashing. The unit starts searching for
another frequency with the same PI (program
identification) data ([PI SEEK] appears).
NO DATA
 There is no program type for the current DAB
service.
 Press
(back).
NO DEV (no device)
 [USB] is selected as source without a USB device
connected. A USB device or a USB cable has been
disconnected during playback.
 Be sure to connect a USB device and USB cable.
NO INFO (no information)
 There is no label information for the current DAB
service.
NO MUSIC
 The disc or USB device does not contain a music
file.
 Insert a music CD.
 Connect a USB device with a music file in it.
NO SERV (no service)
The DAB signal cannot be received.
 Perform an auto scan (page 10).
 Check the connection of the DAB antenna
(aerial).
 Check that [ANT-PWR] is set to [ON] (page 17).
NO TP (no traffic programs)
 The unit will continue searching for available TP
stations.
OVERLOAD
 USB device is overloaded.
 Disconnect the USB device, then change the
source by pressing SRC.
 The USB device has a fault, or an unsupported
device is connected.
PUSH EJT (push eject)
 The disc cannot be ejected.
 Press  (eject).
READ
 The unit is reading all track and album
information on the disc.
 Wait until reading is complete and playback
starts automatically. Depending on the disc
structure, it may take more than a minute.
RECEVING (receiving)
 The DAB band is selected and the unit is waiting
to receive a service.
25
GB