Violectric dac v850 User Manual page 21

Special settings:
To enter the "special settings" push and hold the "RESAMPLING" button
for two seconds. Now the blue "BEST" LED flashes constantly and the
LED from the actual menu flashes once. When the LED is off
afterwards, this menu item is set to default. When the LED is on
permanently the menu item is active.
To alter the menu conditions push the "INPUT SELECT" button.
The next menu item is called up by shortly depressing the
"RESAMPLING" button.
To exit the "special settings" push the "RESAMPLING" button for more
than two seconds.
Menu 1 (OFF) decides, if the digital output carries the
„simple" looped through digital input signal (LED off =
default) or if the digital output signal was treated by the
resampling circuitry (LED lights permanently).
Menu 2 (x1) specifies if the analog outputs are muted
whilst the resampled digital signal and thus the digital
volume control is active on the digital output.
The analog outputs are active when the LED is off =
default, if the LED lights permanently the analog
outputs are muted.
Menu 3 (x2) serves to activate one out of two filters
inside the D/A converters. When the LED is off =
default, the slow/soft filter is active. When the LED
lights permanently the fast/sharp filter is activated.
Menu 4 (x4) defines the phase correlation between
the digital input signal and the analog outputs. When
the LED is off = default the analog signal is in-phase,
When the LED lights permanently the analog signal is
set out-of-phase.
21