Electra Light Beam 300 User Manual page 9

BEAM 300
_____________________________________________________________________
6、r.tilt. [tilt reverse in vertical]
This function allows you to reverse in vertical.
Press " ENTER" to enter, use "UP" or "DOWN", if you need to reverse, please select "ON";
if you don't need to reverse, please select " OFF", press "ENTER" to save and exit, press
"ESC" to exit directly.
7、rset [device replacement]
This function allows you to restart up device to come back to original standard setting. Press
"ENTER" to confirm.
Failure description
Fail to start
the normal lamp
controlled by the controller
Intermittent working
Dim light,
the brightness decrease
Beam impurities (halo)
Serious beam distortion
When the camera has broken and other damage should be promptly replaced.
When the light bulb has deformation, the damage should be immediately replaced.
When the lights brightness decreased, the bulbs may have to use the time limit should
be the timely replacement of aging light bulb has burst danger. When the lamp will not
boot, check whether the lamp power supply fuse blown, such as blown, fuse fitted on
the corresponding specifications. Attention to the need to use the same specifications of
the fuse. Lamps equipped with overheating protection device, when the overheating
protection device will automatically cut off power supply, when this happens, check
whether the normal operation of the fan, fan, fans and whether or not there is dust plug
the Net to find out after the start troubleshooting lamps.
But take note that qualified technical personnel are allowed to carry out
General Troubleshooting
Measure
power fuse
intact bulb
isn't 1. Inspect DMX start address setting
2. check XLR signal lines
Inspect the dust and oil of the fans， whether the
dust plug fans and Nets fans
1.buble's expiry
2.check whether the optical system is clean
Clean the dust and oil of the light bulbs, lenses and
other components
1 Check whether the lens is rupturing
2.Cleaning dust or oil
Maintenance