Table of Contents
Advertisement
BEAM 300
_____________________________________________________________________
2 DN.Pr. （DMX Pre-Setting）
This function let you to choose different operating modes.
2.1
Press the "up" or "down" keys to browse other menus.
2.2
Press "ENTER" to enter, then press "UP" or "DOWN" and choose "nod.1" or "nod.2",
then press "enter" to save and exit or press "ESC" to exit directly.
Nod.1: [mode 1] the normal channel value controlling
Nod.2: [mode 1] the fewer channel value controlling
2.3
To accept the mainframe synchronous (from the models), you have to pre-set the
DMX as "nod.1".
3 Testing Procedures
This function allows you to take inner demonstration procedures without external connector. This
setting will be kept up, If you don't exit the testing procedure, you will automatically enter the
testing procedure, once you start up it every time.
Press "UP" or "DOWN" keys to browse other menus, press "ENTER" to enter.
1.nod. 1 [testing mode 1]
Press " UP" or "DOWN" to select other modes, press " ENTER" to enter, showing
"RUN" testing work. If you need to exit, please press " ESC".
2. nAst:
[mainframe controlling]
This function allows you to test directly, which don't require mainframe to send DMX
synchronous signal to deputy plane.
Press "UP" or "DOWN" to select other modes, press "ENTER" to enter, appear "ON" as
mainframe sending out signal, the DMX signal light on. Appear "OFF" as mainframe don't
sending out signal, the DMX signal light crush out, press " ENTER" to save and exit, press "ESC"
to exit directly. After setting "ON", you have to cut off external DMX controller, which don't
allow two or more mainframes with same setting in the same connecting road.
4 Audi [ Sound- controlled Stimulating ]
This function allows you to use sound stimulated testing prodecudure.
1. Press " UP" or "DOWN" to browse other menus.
2. Press " ENTER" to enter, then press "UP" or "DOWN" and select "ON" or
"OFF" showing whether using sound stimulating or not while testing.. "ON"
shows to use sound controlling, "OFF" shows not to use sound controlling,
controlled automatically in the testing mode. After setting "ON", the audio
signal light will twinkle together with the music in the testing procedure.
5、r.Pan. [ Pan reverse in horizontal ]
This function allows you to reverse in horizontal.
Press "ENTER" to enter, use "UP" or "DOWN", if you need to reverse, please select
"ON"; if you don't need to reverse, please select " OFF", press "ENTER" to save and
exit, press "ESC" to exit directly.
Advertisement
Table of Contents
