Table of Contents
Advertisement
Setup
2. Attach the communication cable of the printer to the till on COM 5 if a PayCon is used for
electronic payments, in all other cases use COM 2.
3. Connect the communication cable of the printer and the cash drawer to the printer.
4. Make sure to connect the earth wire of the cash drawer to the connection bolt.
5. Connect the power cord to the adapter.
6. Plug the power connector into the wall socket.
7. Turn the printer on.
The line display
8. The line display has a number of DIP switches that signify character sets. Check that this setting
is set to the West-European character set. See table below:
Setting
Standaard
Inepro West Europe Off
Set the DIP switches to the West-European character set.
9. Mount the line display foot and pull the cable trough the cylinder.
10. Connect the cable to COM 4. The text 'Mode A' should momentarily be shown on the display
when the system will be started.
10
-
PosPRO
1
2
3
4
5
6
On
On
On
Off On
On
On
On
On
Off On
7
8
9
10
11
12
On
Off On
On
Off On
On
Off On
On
Off On
Advertisement
Table of Contents
