Frequently Asked Questions - Bush 40/233F User Manual

Frequently Asked Questions

General I would like to have
louder sound by
connecting additional
speakers.
General Why are some
options in the menu
unavailable and
greyed out.
General Can I stop my TV
automatically turning
off after 4hrs?
TV I have tuned in
Digital TV but I am
not receiving any or
all of the channels
and/or the channels I
receive are breaking
up.
TV I have re-tuned my
television but when
I switch it off it is not
storing the channels.
VCR/DVD I have connected
Recorder the TV to my VCR or
DVD Recorder via
SCART but it is not
recording.
Game I have connected
Consoles my Playstation/
Xbox to the TV via
HDMI, but I am
not receiving any
pictures or sound on
my Television.
Note:
Supplier may change TV software and on screen graphics without warning
For any help concerning set up and use of your TV please call the Customer Helpline on page 3
30
1) Use the 3.5mm headphone output and a 3.5mm to phono cable
(available separately) to connect to an amplifi er/surround sound system.
Please note this will deactivate the TV's built in speakers.
2) Connect a COAX cable from the TV's COAX output to your amplifi er/
surround systems COAX input.
Some options are only available in certain sources, i.e. HDMI. They are
unavailable in the other sources where they have no affect.
Yes, in the 'Time' menu settings, scroll down to Auto standby and select
OFF.
1) Check you are in an area that can receive Freeview/Saorview, visit
www.freeview.co.uk or www.saorview.ie
2) Check you are using an aerial that is able to receive a good digital
signal. In most cases, you will need an outdoor digital hi-gain/wideband
aerial. In areas that have excellent digital coverage, you may be able
to use a loft type aerial but it is highly likely that you will also need to
connect a booster between the back of the TV and the TV aerial wall
socket. Unfortunately, to receive a good enough digital signal, it is not
possible to use a portable/indoor type aerial.
If the TV does not save the channels when you power it off, it's likely the
channel database has become corrupt.
1) Turn off the TV.
2) Remove the RF/Aerial cable from the rear of the TV and then turn the
TV back on again.
3) Using the remote control, press Menu followed by 8-8-8-8 to enter the
initial setup/fi rst time installation menu.
4) Press OK (let the TV run the full tuning process).
5) Once completed, turn off the TV, reconnect the RF/Aerial cable then
turn the TV back on again.
6) Repeat steps 3 & 4.
In addition to connecting via SCART, you should connect the aerial cable
from the wall socket to your VCR/DVD Recorder and another aerial cable
from the VCR/DVD Recorder to the TV.
1) Ensure the TVs' source is set to HDMI.
2) Check your settings on your Playstation/Xbox are as per the
Playstation/Xbox instruction manual.