Table of Contents
Advertisement
11:1 Armrest, height adjustment
The detachable armrests comes in two varieties, short and long.
The armrest attachment can be fitted in two different heights.
In position 1 the armrest is adjustable between 19-26 cm, and in
position 2 (standard) between 24-31 cm, with 1 cm intervals.
Tools: 10 mm spanner, 5 mm Allen key
The locking claque is used both to install the height and to fix the side
guard to the stem.
-
Loosen the screw that fastens the claque
-
Slide the guard up or down to the desired height.
-
Fasten the screw again.
Tool: 3 mm Allen key.
Never use the armrests to lift the wheelchair.
11:2 Walking stick holder, mounting
-
Mount the holder on the back of the wheelmount with the
screws and nuts supplied (A)
-
Thread the elastic band 'double' around the cane to make a loop
(see illus). The tip of the cane may have to be removed to allow
you to attach the elastic.
-
Place the cane in the holder and stretch the elastic loop over the
push handle.
Tools: 4 mm Allen key and 10 mm spanner.
11:3 Anti-tip stabilisers, mounting
The anti-tip consists of two parts:
-
The attachment bar is mounted under the wheel mount
(see illus)
-
The extension bar with the stabiliser wheel is fixed to the
anti-tip bar at the desired height with screws and nuts.
To allow you to negotiate thresholds and the edges of thick carpets, a
distance of 3-5 cm from the floor to the stabiliser bar is recommended.
Tools: 4 mm Allen key, 8 mm spanner.
When adjusting the seat height, centre of balance or backrest
angle you must check the position and performance of
the anti-tip stabilisers. To swing up the anti-tip, pull out and
swing round.
19
Elastic
A
Holder
1
2
A
Advertisement
Table of Contents
