Technical Specification; Model Numbers - Santon PowerPack Fitting Instructions Manual

INTRODUCTION
Thank you for purchasing a Santon PowerPack. The PowerPack unvented water heater
is manufactured to the highest standards and has been designed to meet all the latest
relevant safety specifications.
This PowerPack instantaneous water heater must be installed (Sections 3.0-6.0),
commissioned (Section 5.0) and maintained (Section 7.0) by a competent person.
Please read and understand these instructions prior to installing your PowerPack
unvented water heater. Particular attention should be paid to the section headed
SAFETY (Section 2.0).
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning the use of the appliance by
a person responsible for their safety. Children should be supervised to ensure that they
do not play with the appliance.
PACK CONTENTS
Heater
Fixing screws and wall plugs
Expansion relief valve 1MPa (10bar)
Tee piece
Fitting Instructions

TECHNICAL SPECIFICATION

MODEL NUMBERS

7.0kW - 94 050 211
9.0kW - 94 050 212
12.0kW - 94 050 213
CONNECTIONS
Inlet / Outlet connection -1/2" BSP male
Water entry point - bottom
Cable entry point - bottom or rear
ELECTRICAL
Electrical rating... 6.4/7.0kW @ 230/240V
.............................8.2/9.0kW @ 230/240V
............................11.0/12.0kW @ 230/240V
2