HIMS E-bot ADV User Manual page 67

② Check the channel setting switch. It can set the channel
values as shown in the below picture. Make sure it is set to
the same channel value as the one shown on the main
body of your E-bot. If the channel value is different, please
use (-) a screw driver or your fingernail to change the
setting.
※ Note: Changing the battery of the wireless controller, if the
wireless controller does not operate even though the channel
value is the same, please change the battery in the wireless
controller.
12.4 Even though the values are the same
channel,
operate normally
a. Replace the batteries in the wireless controller.
the Wireless Controller
P a g e | 67
does not