SoundCraft VI 4 Field Manual page 2

Adding EQ
• Select Channel
• Press the second box down on the channel you wish to
change the EQ on
• Use the encoders to change the EQ parameters
• To Flatten the EQ press and hold FLAT ALL
• To turn different EQ bands on or off press the button
below IN on the relevant band
• To copy EQ settings press the COPY button under the
EDIT SECTION, Press on the EQ curve (a yellow line will
appear)
• To paste EQ settings press the PASTE button under the
EDIT SECTION, then press the EQ curve on the channel
you wish to paste the settings to.
• Press PASTE again to exit paste mode
Adding Dynamics
• Select Channel
• Press the third box down on the channel you wish
to add dynamics to, to open the dynamics pop up
• To turn on the GATE / CMP / LIM press the button
below IN for each processor (it will turn green when
on)
• Use the encoders to adjust the parameters
• To turn the Gate into a Deesser turn the encoder
below GATE / DEES
• To copy a DYNAMICS' setting press the COPY
button under the EDIT SECTION, then press the IN
button for the processor you wish to copy
• To paste a DYNAMICS' settings press the PASTE
button under the EDIT SECTION, then press the DYNAMICS' box on the channel you wish to
paste the settings to.
• Press PASTE again to exit paste mode
Adding Graphic Equalisers (GEQ)
• All outputs have a GEQ
• To adjust the GEQ settings SOLO the output you wish
to adjust the GEQ setting of
• Press the GEQ icon in the middle of the screen
• This will spill the GEQ onto the channel faders
• The frequency will be displayed on the scribble strip
• To flatten a frequency press the ON button above the
relevant fader.