Hobby VAN EXCLUSIVE User Manual page 136

j
Setting the desired temperature in the vehicle.
Can be set between +5°C and +30°C in steps of 0.5°C.
k Heating with gas.
The heating system uses the gas burner. The heating
power of the burner is regulated according to the amount
of heat required.
l Circulation pump.
Displayed when the circulation pump is in operation (12
or 230 V).
m Increased need for hot water.
Increases the water temperature from 50°C to 65°C in 30
minutes.
n Electric heating.
Three power settings can be selected for 230 Volt heating
cartridge. 1, 2 or 3 kW.
o
Power supply 230 V.
Displayed when the vehicle is connected to a 230 V elec-
trical supply.
p
+/On.
Increases or activates a function.
q
Store/Reset.
Saves set time and date as well as resets the system.
r
Right arrow.
Continue in the menu.
s
-/Off.
Decreases or deactivates a function.
11
Left arrow.
Back in the menu
12
Outside temperature.
Shows the outside temperature if a temperature sensor
has been mounted.
13
Menu.
This function can be used to carry out numerous settings
such as:
• setting the temperature on the panel
• key tone
• selecting only the 12 V circulation pump or automatical-
ly switching to the 230 V pump
• continuous operation of the circulation pump
• service functions for the technician
14
Automatic start.
Predefine the time and day at which the heating system
will begin to operate. It then runs for 24 hours.
15
Night-time temperature.
To set the desired reduction in temperature at night. Ma-
nual or automatic.
16
External start (remote link).
To start the heating system from outside the vehicle.
Built-in devices 10-10