From A Remote Touch Tone Phone; Connect With The Answering System; Play Messages - AT&T 1782 User Manual

ANSWERING SYSTEM OPERATION

From a Remote Touch Tone Phone

Connect with the Answering System

1 Dial your telephone number from a touch tone phone with a different telephone
number.
2 When the system answers, enter your three-digit Remote Access Code during or
after the announcement. The system announces the number of messages, then
beeps twice. If the announcement continues to play after you enter your code,
wait for the announcement to end, then re-enter the code.
— OR —
Press # to stop the announcement, then re-enter the code.
3 The two-beep signal lets you know the system is ready to accept a remote command.

Play Messages

1 Connect with the answering system.
2 After the two beeps, wait four seconds, and the system plays back messages
— OR —
Press 1 0 to play all messages in both mailboxes
— OR —
Press 1 1 to play all messages in the Line 1 mailbox
— OR —
Press 1 2 to play all messages in the Line 2 mailbox
— OR —
Press 2 0 to play only new messages in both mailboxes (if there are no new
messages, the system announces,"No new messages")
— OR —
Press 2 1 to play only new messages in the Line 1 mailbox
— OR —
Press 2 2 to play only new messages in the Line 2 mailbox.
NOTE: When you finish listening to messages, press *, 9 before you hang up.
3 To repeat a message — Press 4 while the message is playing.
To repeat part of a message — Hold down 4. To resume playing, release 4.
To skip a message — Press 6 while the message is playing.
To skip part of a message — Hold down 6. To resume playing, release 6.
To stop message playback — Press 5.
To save messages— Press *, 9 then hang up.
34