Page 1
User’s manual part 2 1739 Digital answering system This manual contains information about this product’s installation and operation. Please also read Part 1 - Important product information For customer service or product information,� visit our website at www.telephones.att.com 1 (800)
Installation Parts list Use only the power adapter sup- • Telephone line cord plied with this product. To obtain • �739 answering system a replacement,� visit our website • Wallet card www.telephones.att.com • Part � Important product information 1 (800) 222-3111 or call .
Feature setup Feature setup �. To enter the feature setup mode,� 3. When you hear the feature you want press and hold SETUP until the to modify,� press �NN�/S�IP �NN�/S�IP or system announces “Language is...” MEMO/REPE�T to change the 2. Press SETUP repeatedly to hear each setting.
Page 4
Feature setup Feature summary (continued) FE�TURE S�STEM OPTIONS �NNOUN�EMENT • Choose on to listen to the “Announcement �NNOUN�EMENT announcement when the system monitor is...” MONITOR answers a call. Choose off to silence (Please see NOTE your end of the call (The callers will on the right.) still hear the announcement).
Operation �isten to, save & delete messages • The system automatically saves all number (see Store number incoming messages until you delete under Feature setup on page 3). them. You can store approximately After playing the last message,� 40 minutes of messages,� memos and the system announces “End of announcements (up to a maximum messages.“...
Page 6
Operation announcement: “Hello. Please leave a �uto reset of answering system clock message after the tone.” After you set the time once,� the system �. Press and hold �NN�/S�IP �NN�/S�IP. will always be set automatically with When the system beeps,� speak incoming caller ID information.
Page 7
Operation If you want the system to answer a The system stops recording and you can answer calls. If the system does call when you are playing a message,� P���/STOP P���/STOP to end not disconnect immediately,� press and press release the telephone switch hook. message playback.
Page 8
Operation Memory is full When the memory is full,� or when If there are unreviewed messages,� the 99 messages have been recorded,� F system will play an error tone and will flashes in the message window. You not delete any messages. will then need to delete messages to make room for new ones.
Remote operation �onnect with the answering system You can access many features remotely your code,� wait for the announcement from a touch tone telephone. to end or press # to stop the �. Dial your telephone number. announcement,� then re-enter the 2.
Remote operation Feature summary (continued) FUN�TION: �OMM�ND: Press *9. The system announces “The machine will END REMOTE ���ESS ���� now hang up,“ and disconnects the call. NOTE: If no commands are entered for �5 seconds the system will announce “The machine will now hang up”...
Page 11
In case of difficulty �nswering system operation System does not • Make sure you are calling from a touch tone respond to remote telephone. When dialing a number,� there should command. be audible tones. If there are clicks instead,� the telephone is not a touch tone telephone.
General product care To keep the answering system working and looking good,� follow these guidelines: • Avoid putting it near heating appliances and devices which generate electrical noise (motors,� fluorescent lights,� etc.) • DO NOT expose it to direct sunlight or moisture. •...